Nut rivet setter (air) AN200A

Nut rivet setter (air) AN200A

* This is no longer produced.

・Lightweight spin-pull rivet nut setter
・Sets up to 3/8" (M10) aluminum and steel rivet nuts (see table below)
・Rapid placement sequence
・One stage trigger - only one actuation of trigger spins rivet nut onto threaded mandrel, collapses rivet nut, then reverse spins itself out of completed setting
・Easy stroke adjustment dial
・In case of operator error, activation of unique reverse lever removes screw mandrel from rivet nut without damage or down time
・Wear-resistant surface extend tool life
・Rugged aluminum diecast construction

CEROHS

仕様

Nut rivet setter (air) AN200A

品番 商品重量 寸法1 寸法2 寸法3 寸法4 寸法5 使用範囲 使用エアー圧(MPa) 参考価格
AN200A 2.600g 270mm 287mm 48mm 35mm 25mm M3、M4、M5、M6、M8、M10 0.6~0.7 オープン価格

!使用上のご注意

・Be sure to read the instruction Manual and important Usage Advisery carefully and make sure that you understand them thoroughly before using this tool.
・Be sure to use under condition of construction.
・At the time of the attention and the activity in case of application, wear an eye protector.

!表記数値のご注意

※ 寸法・重量などは公称値ですので、多少の数値の上下があります。
※ 改良の為、仕様等を予告なく変更することがあります。
※ 記載の価格は「参考価格」で消費税は含まれておりません。
ご購入の際はLOBSTER(エビ印)商品の取扱店にご確認ください。