検索

Zet flashar for both iron and stainless steel φ80～180㎜ FX-A

Zet flashar for both iron and stainless steel φ80～180㎜ FX-A

Carbide tipped saw for both iron and stainless steel
Focused on cutting performance. Excellent cost performance.

Focused on cutting performance and cost efficiency, this carbide-tipped saw cleanly cuts general soft steel, stainless steel (SUS304), iron plates, angles, ALC, and aluminum. It delivers excellent durability and smooth cutting across a wide range of metal and construction materials.

・For general soft steel (iron, aluminum), stainless steel (SUS304), iron plate, angle, various siding, ALC, aluminum, etc.



●For target materials, see here.
--->Target material table (Tipped saw)

仕様

Zet flashar for both iron and stainless steel φ80～180㎜ FX-A

品番コード 商品重量 寸法１ 寸法２ 寸法３ 最高回転数 刃数 参考価格 備考
FX80A 70g 80mm 1.8mm 20mm 15000(min-1(rpm)) 14 オープン価格 Maximum cutting thickness for iron： 4 mm
Maximum cutting thickness for stainless steel： 2 mm
FX100A 120g 100mm 1.8mm 20mm 13000(min-1(rpm)) 20 オープン価格 Maximum cutting thickness for iron： 4 mm
Maximum cutting thickness for stainless steel： 2 mm
FX110A 140g 110mm 1.8mm 20mm 13000(min-1(rpm)) 22 オープン価格 Maximum cutting thickness for iron： 4 mm
Maximum cutting thickness for stainless steel： 2 mm
FX125A 210g 125mm 1.8mm 20mm 7500(min-1(rpm)) 26 オープン価格 Maximum cutting thickness for iron： 4 mm
Maximum cutting thickness for stainless steel： 2 mm
FX160A 360g 160mm 2.0mm 20mm 6000(min-1(rpm)) 32 オープン価格 Maximum cutting thickness for iron： 6 mm
Maximum cutting thickness for stainless steel： 3 mm
FX180A 440g 180mm 2.0mm 20mm 5500(min-1(rpm)) 40 オープン価格 Maximum cutting thickness for iron： 6 mm
Maximum cutting thickness for stainless steel： 3 mm

!使用上のご注意

･Before using this product, be sure to read through the instruction manual included with the product and the operation manual provided by the electric tool manufacturer, to understand the contents thoroughly.
･Properly attach the protective cover specified by the electric tool manufacturer.
･The tipped saw generates sparks during use.
･Do not use the tipped saw in a place where ignition or explosion may occur.
･During work, be sure to wear protective gear (dust-proof goggles, safety shoes, protective cap, dust-proof mask and ear plugs).
･Use a circular saw whose rotational speed is lower than the maximum operating rotational speed specified in the instruction manual.(Do not use this tool with disc sanders, grinding wheel cutters, low-speed cutters [for metal saw] or rechargeable tools.)

!表記数値のご注意

※ 寸法・重量などは公称値ですので、多少の数値の上下があります。
※ 改良の為、仕様等を予告なく変更することがあります。
※ 記載の価格は｢参考価格｣で消費税は含まれておりません。
ご購入の際はLOBSTER(エビ印)商品の取扱店にご確認ください。